Made of Rustproof Stainless Steel and Smooth Wooden Handle Which Can Save Labor Power in Beekeeping!

Originally, this tool was used to scrape the cappings’ low places that the uncapping knife or plane missed. The cappings scratcher was also discovered to be useful as an inspection tool. One might stick the fork tines into the drone brood and pull it out, looking for female Varroa mites on the white drone larva. Just a few tines are scratched and pulled at a time, putting a lot of power on the tines, and it’s only a matter of time before the end times bend or pull out of the plastic. Uncapping the honey cells is a third application for the fork. The entire width of the fork tines is placed just below the cappings, and the beeswax is drawn upward. The honey can now be strained through a fine wire screen to remove the wax and other big debris and then left to sit for a bit to allow the air bubbles to rise, allowing it to be labeled as raw honey.

Buy Beekeeping Tools Honey Cutter Uncapping Honeycomb Scraper today.


• Material: Wood + Stainless Steel

• Color: Silver with a hint of wood

• Dimensions: as depicted in the image

• High tensile strength and abrasion resistance.

• It’s simple to use.

• Long-lasting in use.

A close up of a comb


• The fork, which has metal tines and a wooden grip, is an upgrade.

• There are no indentations in the handle for your fingers to be packed into, so it’s comfortable to hold.

• The fork has a scraper on one side.

• Be careful not to shatter the sterling silver set and just utilize the tips, as they may rapidly become a disaster.

• You’ll have to make more swipes to get the job done with conventional forks because they’re so narrow.

• Wax removal is less intrusive.

• Enables you to comb around corners and oddly shaped combs

{ -Upload Image from the website + clickability to product -}

Engineering drawing


• It’s probably the most time-consuming to use.

• The most time-consuming


Honey production is an exact science for the honeybee. The bees fan the honey with their wings to eliminate any surplus moisture until the honey is 17 percent saturated. They next use wax capping to seal each comb. Beekeepers may opt to extract honey from honey frames before the bees have had a chance to cap the cells. This indicates that the honey has not yet matured and will still have a higher water content than is ideal. The frames must next be dehumidified before the honey can be extracted. 

Honey gathering is, without a doubt, the most intriguing and rewarding aspect of beekeeping. The honey extractor is still a vital instrument for extracting honey without causing damage to the combs. Whether you’re looking for a commercial or hobbyist extractor, one that’s electric or manual, make sure you obtain the one that’s perfect for you.

Subscribe to our monthly Newsletter
Subscribe to our monthly Newsletter